Dual 701 stroboscoop ring

  • Hallo
    Have a dual 701 as new aquired
    The paper strobe ring is fallen of the platter
    Wat is the best way to fix it on the underside of the platter again
    Automatic dont work but i hope its the famous steuerpimpel
    Not looked inside yet
    Regards carlos

  • Hi Carlos !

    Wat is the best way to fix it on the underside of the platter again

    As long as the paper hasn't been damaged or is bended or wobbly you could use a glue like Pattex (as used for carpets).
    It allowes to adjust the paper for a while before it finally dries.
    You might place the platter on a flat surface with the ring facing up and after applying the glue on the aluminium you have to wait for some minutes until the glue dries a bit and gets harder. Then place the paper ring on it and - if possible - use some smaller items to put even pressure on it to avoid "building up waves" (bulging).


    Did that a few times with the 1228 platter, which is notorious for wobbly strobo ring, which partially come off and scratch on the stroboscope housing at each revolution making nasty noises.


    ^^

    Peter aus dem Lipperland


    Solo mio, vendro unscrupuloso, custombres sansaclu.

  • at each revolution making nasty noises

    The reason for this neither must be the platter, nor the strobe! Sometimes you'll get that effect from otherwise absolutely flawless vinyls! :whistling:


    @ carlos: I beg your pardon for hijacking your thread... Peter has said it all! :thumbup:

  • ok, thanks
    problem solved with paper glue spray
    one thin film on platter and paper ring
    carlos

Jetzt mitmachen!

Du hast noch kein Benutzerkonto auf unserer Seite? Registriere dich kostenlos und nimm an unserer Community teil!
Nach der Registrierung können Sie aktiv am Forenleben teilnehmen und erhalten Zugriff auf weitere Bereiche des Forums.